| 1. |
Disconnect the negative (-) battery
terminal. |
| 2. |
Remove the hazard lamp switch assembly
(A).
|
Take care not to damage and scratch the
hazard lamp switch assembly and its related
parts.
Apply the protective tapes to the hazard
lamp switch assembly and its related
parts. | |
| 3. |
Disconnect the connectors (A).
|
| 4. |
Remove the center fascia panel
(A).
|
| 5. |
Remove the audio assembly (A) after loosening
the mounting screws.
|
| 6. |
Disconnect the audio connectors and cable (A),
then remove the audio unit completely.
|
When the compact disc is not ejected, do
not remove it
forcibly. | |
| 1. |
Connect the audio unit connectors and
cable. |
| 2. |
Install the audio
unit. |
| 3. |
Install the center facia
panel. |
| 4. |
Install the hazard switch
module. |
| 5. |
Connect the negative (-) battery
terminal.
|
Make sure the connector are connected in
properly.
Check the audio
system. | |
| 1. |
When separate the CD rom drive, if necessary,
remove the brackets (A) after loosening the screws
(6EA).
|
| 2. |
Remove the screws (4EA) on the head unit and,
and then disassemble the top cover (A).
|
| 3. |
After loosening the screws, remove the CD rom
drive (A).
|
Take care not to damage the cable
connectors (B) when removing
drive. | | |
